How to install notto hid lights

Posts Latest Activity. Page of 1. Filtered by:. Previous template Next. I did a search and only found one result that had anything to do with a notto kit, and i found it quite useless. Has anybody used this kit or read any reviews on it, as i cant seem to find much about it anywhere, exept for the fact that it does not come with a cover. I would most likely buy the projector headlights for my mazda 3 along with the HIDs, and i was looking at getting k.

Any feed back would be appreciated! So, you can now compare the difference between the lifespan of the halogen bulb and HID bulb. An HID bulb provides excellent visibility in comparison to a halogen bulb. The light produced by an HID bulb covers three times the area of a halogen bulb. So, it enables the driver to visualize correctly during the night.

The HID lights have high energy efficiency in converting energy into light. An HID bulb can generate lm per watt. If you compare with halogen bulbs, then they generate 25 lm light per watt. HID kit installation is not a difficult task. You will surely get brighter light after installing an HID kit on your vehicle.

There is a popular question about how to install an HID conversion kit. For HID kit installation, you need to follow the below steps. The steps are as follows. The next step is to remove the old halogen bulb from your vehicle. So, for this, you need to disconnect the battery terminal and then gently remove the halogen bulb. Try to wear gloves while removing the bulb. In some vehicles, you will find a different housing for the bulb, So to remove the halogen bulb, you need to remove both headlight housing and the bumper together, which will take a lot of time.

You try to remove the HID bulb from the plastic cover gently and insert the bulb on the housing. If by mistake you touched it, then you need to clean the HID bulb with alcohol. Now place the HID bulb precisely in the same place where the halogen bulb was there. Then seal your headlight housing with a dust cover so that no dust will enter into the HID bulb and affect its efficiency.

Now for mounting ballast, you need a bracket. Brackets are readily available in the market. So, you can buy anything according to your choice. But never mount your ballast by drilling holes or with the help of tape. I contacted Xtreme vision and they sent me another cable. This cable goes between the bulb and the ballast Where does the small 2 wire male plug go? Sorry but the information in this instructable is incorrect and illegal. When you swap out bulbs for HIDs you are changing the way the light is projected and put others at risk of being blinded.

This requires you to take the headlights apart and install an HID specific projector to properly control the light. Otherwise you are blinding other motorists and causing a hazardous situation.

More by the author:. Test the HID light to see if it lights up. If not, flip the adapter degrees.